Users Manual

5
- Scan the QR Code on the the security light camera.
- Follow the EZVIZ app wizard to nish Wi-Fi conguration.
If you want to change your security light camera's Wi-Fi, press and hold the reset button for 5s and repeat this part.
• The security light camera works with 2.4GHz Wi-Fi signals. If you have a dual-band router with separate 2.4GHz and 5GHz networks,
make sure your phone is connected to the 2.4GHz one.
• If your Wi-Fi network signal is less than 50% where you want to install the security light camera, a Wi-Fi signal extender is recommended
to boost the signal at the installation point.
Appendix
Install Memory Card (Optional)
- Remove the door on the side of the camera.
- Insert a microSD card into the slot until a click.
- Place the door cover back on.
Initialize Memory Card
1. In the EZVIZ app, check the memory card status by tapping on the Storage Status in the Device Settings interface.
2. If the memory card status displays as Uninitialized, tap to initialize it. The status will then change to Normal.
For detailed information, please visit www.ezvizlife.com.