Use and Care Manual

Assembly Instructions
Defender Sectional Flagpole
Flying Your Defender Flag at Half-Mast
*To y your ag at half-mast on your Defender Sectional agpole you will
want to unclip your ag from the top swivel and rst 2” bottom swivel sleeve.
*Clip the top clip of the ag to the rst 2” bottom swivel sleeve which will
rest on the button. The bottom clip of the ag will clip on to the second
2” bottom swivel sleeve.
The bottom of the flag attaches
to the top hole of 2” Swivel
Sleeve with stainless steel clip.
The top of the flag attaches to top
swivel with stainless steel clip.
The second 2” Swivel
Sleeve is used when flying
a second flag.
Assembly Instructions
Defender Sectional Flagpole
Once Ground Sleeve has been installed and had proper time to cure,
you can assemble and insert your agpole.
The Top Section with Top Cap installed will go at the very top of the
agpole.
l If you have the 13’ or 17’ model, the top section will have a
button installed.
l If you have the 21’ model, the section with the button
should be placed beneath the top section (second from the top).
The button will be used for half-mast purposes, and the rst 2” bottom
swivel sleeve will rest on the button.
Remaining plain sections to go underneath top section and section
with button.
D-21 image shown. (*Note not all vendors include ag)