Quick Start Guide

6
6. Mounting Your Camera
Using an appropriately-sized bit, drill two pilot holes 1-¾” apart.
You can also use the template on the next page to mark your
pilot hole locations.
Using a 3/4” bit, drill a wiring access hole centered between
your two pilot holes (to accommodate the camera’s wire
connections through the wall).
After drilling these holes, insert the camera’s wires through the
wiring access hole and secure the camera to the wall with the
two provided screws.
Note: Installations into softer wall materials will require use of
the included plastic wall anchors.
5. Testing Wi-Fi Strength at the camera location
1. Bring your smartphone near your preferred camera
location.
2. Make sure your phone is connected to your home Wi-Fi
network.
3. With your phone, visit a website or stream an online video.
4. If websites and videos load and play quickly, then the
location most likely has acceptable Wi-Fi coverage.