Service manual

ENGINE REASSEMBLY
Page E-5
Engine Shop Rebuild and Parts Manual
Install the Rocker Cover
(See Fig. E-8 “Rocker Cover” on page D-13)
A. Install a new rocker cover gasket (ITEM 2) in the
cover. Match the shape of the gasket to the shape of
the cover for proper orientation.
B. Match the shape of the rocker cover (ITEM 1) to the
shape of the mounting surface for proper orientation,
and position the cover on the cylinder head. Make
certain that the six (6) spacers sleeves (ITEM 4) are
installed in rocker cover. (DETAIL A)
C. Using a 10mm socket, install and tighten six (6) bolts
(ITEM 3, M6x1.0x23L) to specified torque in two
stages, in the order shown.
Install the Carburetor
(See Fig. E-9 “Carburetor” on page D-14)
A. Install the gasket (ITEM 2), plastic insulator (ITEM 3),
and gasket (ITEM 4) on the carburetor mounting
studs.
B. Place the carburetor on the mounting studs with the
choke side out.
C. Insert one carburetor vent hose (ITEM 5) through the
hole in the PCV cover plate. Be certain that it is not
crimped or blocked in any way.
D. Install new gasket (ITEM 6) and the air cleaner/car-
buretor seal plate (ITEM 7).