User manual

Tools required Tools are the rst step to proper assembly,

you will need a

Allen / Hex key metric set

Philips head screwdriver

Open-end at wrenches metric

measurements 6mm - 17mm

Front wheel Insert the hub motor wheel into the front fork,

ensuring that it is properly seated in the dropout slots. Tighten the

nuts alternatively on both sides till the wheel is secured.

Tightening torque 35 Nm

Seat post Insert into the seat tube of the bicycle frame

and align. Tighten clamps and ensure seat is rmly fastened.

Tigtening torque 16 Nm

Do not adjust the seat post beyond its maximum extension

mark.

Headstem Align headstem and handlebar so that it is

perpendicular to the frame before tightening as shown below.

Torq

Assembly