Owner`s manual

50
015885 rev 10-00
Ladders
42
ladder installation
Preread the entire ladders section (pages
50 - 53) before installing the ladders.
Refer to the ladders, safety cages and
platforms manual for specific assembly
instructions. Attach the ladder to the bin
sidewall while building the bin from top
to bottom (fig.s a - g). The first ladder
bracket should be located about 8”
below the eave (fig. e). Field drill this
connection. Thereafter brackets are
designed to be located at every
horizontal seam. Be sure that all the
brackets and splices are properly spaced
and securely tighten all bolts. Use bin
bolts and nuts for the assembly. Fasten
the safety cage to the ladder using the
clip and bolt assemblies provided.
OUTSIDE LADDER WITH CAGE ASSEMBLY
b
outside ladder with cage shown
ladder section
outside ladder bracket
ladder cage d-ring
ladder cage upright
NOTE: OSHA Regulation -
Subpart D., Section 1910.27 (d)
(iv) states in par: “Cages shall
extend down the ladder to a point
not less than seven (7’) feet nor
more than eight (8’) feet above the
base of the ladder.”
TOP VIEW OF LADDER CLIP AND BOLT
a
LADDER CLIP AND BOLT,
PREASSEMBLED
NOTE how the
clip flattens out.
TOP VIEW OF LADDER CLIP AND BOLT
c
LADDER CLIP AND BOLT,
ASSEMBLED