Owner`s manual

47
015885 rev 10-00
STEP 40
Install the anchor clip keeper at the vertical seams of
the bottom sidewall ring. The bottom leg of the keeper
will fit below the base angle (fig. e and f). While the
bin is still suspended apply the base sealer to the
bottom of the base angle. Lower the bin so that it is
inside of the anchor bolt circle. Be sure that any
anchor bolts below the transition are cut off prior to
lowering the bin. Secure the bin to the foundation
with the base angle clips as shown (fig. g).
bottom sidewall ring
base angle
flange nut
anchor clip keeper
bin bolt
hex nut
flat washer
base angle clip
e
base connection at vertical seam
anchor bolt
STEP 41 (batch units only)
Install the winch bracket and winch
approximately 48” above the concrete as shown
in figure i. Trim the cable as required and attach
it to the winch. The travel of the cable must be
limited to prevent damage to the dump hoppers.
After insuring that all dump chutes are level,
attach a cable clamp to the cable as close to the
winch drum as possible. This clamp acts as a
visual indicator of when to stop raising the dump
chutes. Release the cable from the winch until
this clamp is approximately 30” above the winch
drum and attach a second cable clamp to the cable
beneath the outer pulley bracket near the top of
the bin sidewall (fig. h). This clamp prevents over-
opening of the dump chutes. Make sure that the
chains are tight before the chutes interfere with
the hopper neck when in the lowered position.
STEP 41
(continuous flow units/
automatic batch units)
Install the hydraulic pump unit along with the
cylinder/accumulator assembly as shown in figure
j. Trim the cable and attach it to the cylinder using
two cable clamps. Connect the hose between the
pump unit and the cylinder. Field drill all holes.
h
winch
mounting
bracket
field drill (3) holes
cable
g
base connection at
all other locations
f
base connection at
vertical seem assembled
outside pulley
brackets
cable clamp to
limit downward
travel of spouts
cable clamp
cable stop
winch
bin wall
cable
cylinder
accumulator
foot pad
pump unit
j
i
field drill holes
24
36