Owner`s manual

33
015885 rev 10-00
21’ DIAMETER ROOF
1. Install the first eave clip starting with the first square hole in clip as shown in figures a and b.
2. Skip (4) holes and install second clip starting with the first square hole in clip, as shown.
3. Repeat step 2 until all clips are installed.
NOTE: The same results can be obtained using a strap or angle gauge with 5/16” pins or 3/8”
holes at 16 1/4” centers. (See Figure c)
24’ DIAMETER ROOF
1. Install the first eave clip starting with the first square hole in clip as shown in figures a and b.
2. Skip five (5) holes and install second clip starting with the first square hole in clip, as shown.
3. Repeat step 2 until all clips are installed.
NOTE: The same results can be obtained using a strap or angle gauge with 5/16” pins or 3/8”
holes at 19 1/2” centers. (See Figure c)
27’ DIAMETER ROOF
1. Install the first eave clip starting with the first square hole in clip as shown in figures a and b.
2. Skip six (6) holes and install second clip starting with the first square hole in clip, as shown.
3. Repeat step 2 until all clips are installed.
NOTE: The same results can be obtained using a strap or angle gauge with 5/16” pins or 3/8”
holes at 22 9/16” centers. (See Figure c)
30’ DIAMETER ROOF
1. Install the first eave clip starting with the first square hole in clip as shown in figures a and b.
2. Skip seven (7) holes and install second clip starting with the first square hole in clip, as shown.
3. Repeat step 2 until all clips are installed.
NOTE: The same results can be obtained using a strap or angle gauge with 5/16” pins or 3/8”
holes at 25 11/16” centers. (See figure c)