Owner`s manual

015885 rev 10-00

Important Pre-Assembly Info

SIDEWALL SHEET IDENTIFICATION

The bin wall sheets are color coded on the end of the sheets for easy reference as follows:

Green/Gray - 19 Gage Yellow/Black - 13 Gage

Red - 17 Gage Black - 12 Gage

Blue/Yellow - 15 Gage Orange - 11 Gage

Yellow - 14 Gage

To determine the number of sheets per ring, divide the bin diameter by three:

ie: 24' diameter bin divided by 3 = 8 sheets per ring.

BIN HARDWARE AND WHERE IT IS USED

#12 x 3/4” self drilling screw

Used to attach the flashing sealer to the flashing

1/4” x 3/4” bolts and flange nuts

Used to bolt the dump hoppers to the plenum sheets

1/4” x 1” bolts and (2) nuts

Used to bolt the dump chutes to the dump hoppers

5/16" x 1" bin bolts w/ seal washer and nuts

Used in bin sidewall sheets and roof sheets

Used around the door.

Used on the stiffeners

Used at the door and step across platforms

Used at the roof rafter braces

Used at grain bands

5/16" x 1-1/4" bin bolts w/ seal washers and nuts -

Used to bolt the bottom sidewall sheet to the base angle

Used at the tension angle splices

Used at the horizontal seam between the top half sheet and the first full sheet

5/16” x 2 3/4” bolts and nuts

Used at the tension angle / horizontal sidewall seam

Used to bolt the plenum sheets to the plenum rafters

5/16" Flange nuts -

Used under all roof ribs and at plenum sheets

Used at all stiffeners

Used at the tension angle

Used at the perforated roof flashing

Used at the grain bands

5/16" Metal backed neoprene washer

Used at the horizontal sidewall seam with the 5/16” x 2 3/4” bolts