Owner`s manual

12
015885 rev 10-00
Specifications
This bin is designed along guidelines which allow it to provide the owner years of service
provided it is not used for purposes for which it was not intended. The sidewall gage
specifications for your bin appear on the sidewall sheet layout on pages 48 and 49. The
general material specifications for your bin are as follows:
WALLS
All wall sheets are of corrugated, galvanized steel with 2.66" corrugation.
Wall sheets have .90 oz. per square foot zinc coating (G-90 designation).
2.66" corrugation sheets have 32" vertical coverage. The half ring covers 13 1/3”.
Horizontal coverage of wall sheets is 112 1/2".
All 5/16" bolts are electro-galvanized grade 8.2 with self-sealing injection molded washers.
Sealer Strip is provided to seal all vertical sidewall seams.
Base Sealer is provided to seal between the bin and the concrete foundation.
Anchor Bolts are standard with all Ezee Dry bins.
STANDARD ROOFS
All single span sheets through 30' diameter are made of 22 gage galvanized steel
18'-30' bins have a 36" opening at the peak with a 2 1/4" rib height.
One manhole roof sheet is standard on each bin with a hinged lid and one of two sizes of
openings. A 3.7 square feet of opening for 18’, 27’ and 30’ bins. A 2.6 square feet of opening for
21’ and 24’.
A roof ladder from the eave to the peak and a roof safety ring is standard with each bin.
Steep 32° roof slope.
All roofs, 21'-30' have 36 sheets per roof. The 18’ roof has 34 standard sheets and a double
wide manhole sheet.
Roof sheets are attached to sidewalls with specially designed eave clips.
Loading:
Live Load - 25 pounds per square foot
Dead Load - 3 pounds per square foot
Wind Load - 20 pounds per square foot
Concentrated Peak Loading:
18'-30' - 2000 pounds