Owner`s manual

57
015886 5-02
48 (Vac-U-Vents only)
attach the control rods
Locate the handle assembly about 48” from
the ground (fig. d). Drill (2) 3/8” diameter
holes in the sidewall to match the bracket.
Slide the control rod through the set collar
on the handle then bolt the handle bracket
to the sidewall. With the Vac-U-Vent fully
closed and the handle in the down position,
tighten the bolt in the set collar.
49
secure the bin to the foundation
While the bin is still suspended apply the
base sealer to the bottom of the base angle.
Attach stiffener base clips to the bottom of
the stiffeners (fig. f). Put base plates on the
inside anchor bolts. Lower the bin to the
foundation connecting the stiffener base
clips to the inside anchor bolts. Be sure that
any anchor bolts below the transition are
cut off prior to lowering the bin. Place base
angle clips onto the outer anchor bolts and
tighten all anchor bolt nuts to finish securing
the bin to the foundation (fig.s e and g).
ATTACH THE CONTROL ROD
d
handle
assembly
field drill
control rod
BASE CONNECTION AT OUTER ANCHOR BOLTS
e
bottom sidewall ring
base angle
flange nut
5/16” x 1 1/4”
bin bolt
hex nut
flat washer
base angle clip
anchor bolt
base connection at
all outer anchor bolts
TIGHTENED OUTER BASE CONNECTION
g
NOTE: Shim under base
plates as required (shims not
supplied by MFS/York/Stormor)
INSIDE STIFFENER / BASE CONNECTION
f
base plate washer
base clip
base plate
base stiffener
base angle
5/16” x 1”
carriage
bolts and
flange nuts