Owner`s manual

54
015886 5-02
43
install the access door
Insert the correct door frame (32” or 64”)
into the opening created by the special
length sheets. Use sealer tape on all four
sides of the opening. Attach the cover
to the frame at the hinges and install
the lock assembly (fig. a). Bolt the outer
door clip to the sidewall on the hinge
side to keep the door cover fixed in
position when open (fig. b). Fasten the
striker plate to the door jamb (fig. c).
Adjust the cam so that the door will close
tightly. Use this same method to install
the lock in the upper access door.
Doors
42
locate the access door
One ring access doors (32” doors) are
to be located in the second ring from
the bottom. Two ring access doors (64”
doors) are to be located in the second
and third rings from the bottom. Special
sheets are provided to accommodate the
door frames (fig. c & d on page 53.
These sheets will need to be field drilled
for the stiffeners.
FASTEN THE STRIKER PLATE
c
door frame
striker plate
BOLT ON THE OUTER DOOR CLIP
b
5/16” x 1”
bin bolt
field drill
3/8” hole
INSTALL THE LOCK ASSEMBLY
a