Owner`s manual

015886 5-02

Maintenance

Virtually the only thing that will limit the useful life of your bin is rust.

MFS/YORK/STORMOR has specified a galvanized coating on the steel used to

fabricate your bin that will give many years of service if properly maintained.

However, some rusting over a period of years can be expected with any galvanized

products exposed to the weather. We suggest the following:

1. Do not allow the galvanized surfaces of your bin to become cluttered

with grain or foreign material. As these organic materials deteriorate,

they produce acids that may cause immediate damage to the galvanized

coating. Clean off any such buildups immediately.

2. Check the horizontal surfaces of your bin for any rain water ponding. Dry

and correct the source of ponding immediately.

3. The useful life of bins installed in coastal or acid rain areas may be improved

through periodic rinsing of the exterior surfaces with fresh water.

4. After unloading your bin, any organic material clinging to the interior

walls or floor should be removed.

5. Any large areas of zinc oxidation, commonly called “white rust”, may

eventually lead to deterioration of the base steel itself exhibited by the formation

of normal “red rust”. Small areas of white rust may be periodically repaired

by steel brushing and touch up painting with a wash primer and enamel paint.

Large areas of white rust or any red rusted areas should be repaired by sanding

to base metal and painting with a quality zinc-rich paint.

Besides stopping the premature development of rust, other things you should

periodically check are:

1. Any obvious foundation settlements. Major settlement may cause structural

failure of your bin.

2. Deterioration or looseness of any bolts or fasteners.

3. Continued secure attachment of all sidewall and roof ladders.

4. Proper functioning and attachment of all bin openings such as roof caps.

Be sure all latches and hold down clips are used as intended.

5. Since your bin is equipped with a floor, periodically remove the fan

transition and check beneath the floor for the condition of the floor

supports, pests, or a buildup of dust or FM. Clean or repair as required.

6. MFS/YORK/STORMOR strongly suggests that any mechanical or electrical

auxiliary equipment installed in or on the bin be checked on a yearly basis by

a qualified service technician. Consult your dealer for this service as they

are well versed in the care and maintenance of this equipment.