Owner`s manual

46
015886 5-02
31
mount outside pulley brackets
At the place where the winch (batch
dryer) or hydraulic unit (continuous flow
dryer) is to be located mount the outside
pulley brackets to the sidewall (fig. a).
The pulley should be positioned so the
cable will run beneath a purlin. Drill a
hole in the sidewall where the 1/4” cable
will pass through as shown.
32
attach the chain disk
Connect the 3/8” x 1 1/4” eye bolt to
the center of the chain disk (fig. b). Pass
the 1/4” cable through the eye bolt and
secure it with two cable clamps. Thread
the free cable end through the center
pulley. This end will attach to the winch
or hydraulic cylinder (see step 50).
Install Chain Assemblies
MOUNT THE OUTSIDE PULLEY BRACKETS
a
1/2” x 2” bolt
main pulley angle
pulley small pulley angle
field drill 9/16” cable hole
and 3/8” bracket holes
sidewall section
OUTSIDE PULLEY BRACKETS ASSEMBLY, TOP VIEW
b
1/2” x 2” bolt
pulley
5/16” x 1” bin bolts
and nuts
sidewall
main pulley angle
small pulley angle
ATTACH THE CHAIN DISK
c
cable clamp
chain disk
eye bolt