Owner`s manual

43
015886 5-02
28
put the roof cap assembly together
Bolt the roof cap slide rod brackets to the
roof cap with 5/16” x 1” bin bolts and
flange nuts (fig. c, page
42). Fasten the
slide rod tabs to the peak ring with 1/2”
bolts (fig. d). Insert the slide rods through
the upper holes in the tabs and thread a
nut onto the rod (fig. c detail, page 42).
Place the rod through the slide rod bracket
and nut on that side also. Double nut the
other end of the slide rod at the roof cap.
Locate the roof cap hold-downs as shown
(fig.s e and f).
ROOF CAP HOLD-DOWN LOCATIONS
e
120º
typical location of cap hold-down
FASTEN THE SLIDE ROD TABS
d
slide rod tab
(011590)
peak ring
(011402)
1/2” x 1”
Roof Steps
.oNtraP
llarevO
htgneL
837210"8/58
684110"51
884110"8/181
094110"8/112
294110"8/342
694110"2/103
894110"4/333
005110"8/763
205110"8/793
INSTALL THE ROOF CAP HOLD DOWNS
f
wing nut
roof cap (011400)
hold down
clamp
(011589)
cap flashing
(011401)
peak ring
(011402)
roof sheet