Owner`s manual

24
015886 5-02
Sidewall Construction
sidewall sheet
overlap
SHEET OVERLAP ONE DIRECTION ONLY
c
upper panel
lower panel
5/16” bin bolt
w/seal washer
5/16” hex nut
outside of bin
inside of bin
HORIZONTAL SHEET SEAM
b
sealer tape
6” - 12”
sidewall sheet
SEALER TAPE AT SIDEWALL SEAMS
a
IMPORTANT!
Instructions to follow throughout
the building of the sidewall
1. All sidewall sheets are color
coded per the table on page 18
for ease of construction.
2. See the sidewall layout sheet
table on page 59 for sidewall
sheet gage and placement.
3. A lways overlap the sidewall
sheets in the same direction
as shown (fig. c).
4. Use one row of sealer tape at all
vertical joints and horizontally
for 6-12” from the end of each
sheet (fig. a). Wipe sheets clean
before applying the tape.
5. Bolt sidewall sheets together with
the bolt head and seal washer to
the outside of the bin and the nut
to the inside. At Stiffener
locations the bolt direction is as
indicated in fig. b on page
27.
6. The sheets should be
staggered in halves. The
halves measure ~56 1/4”.
7. T he top sidewall ring is hole
punched differently. It is punched
for the roof and does not have
any stiffener hole punching.
8. The second ring is also punched
differently for the dryer
assembly (fig. a, page
26).
9. At horizontal seams, bolt lower
sheets to the inside of upper
sheets (fig. b).