Owner`s manual

015886 5-02

Bin Hardware, continued

3/8” x 1” hex bolts, flat washers and nuts -

Used to assemble the fan platform.

Used at the winch on batch units.

1/2” x 1 -1/2” hex bolts, flat washers and nuts -

Used to bolt the intermediate purlins to the purlin mounting angles.

1/2” x 2” hex bolts, lock washers and nuts -

Used at the pulleys.

1/2” x 10” anchor bolts, washers and nuts -

Used to secure the bin to the foundation.

3/4” x 1 - 1/2” hex bolts, nuts -

Used to bolt the main purlins to the center collar and top stiffener.

Sealer tape -

Used on bin wall seams (one strip vertically and 6-12” horizontally).

Used both vertically and horizontally around door frame.

Roof eave clip -

Attaches the top ring of the sidewall sheets (place on the outside). The

top set of holes puts the roof in a lowered position for a storage application

and the bottom set puts the roof in a raised position to facilitate drying.

Roof cap hardware -

Roof cap slide rod bracket.

Roof cap hold down bracket.

Roof cap slide rod tab.

Roof manhole hardware -

Manhole hinge.

Manhole hinge bracket.

Manhole latch catch.

Manhole latch side.

Manhole latch bushing.

Door hardware -

Outer door clip.

Striker plate.

Door T-handle.

#8 x 3/8” screw.

#8 external tooth lock washer.

#8 - 32” hex nut.

1/4” x 1/2” hex bolt and flange nuts.

UNDER NO CIRCUMSTANCES SHALL ANY OTHER BOLT

BE SUBSTITUTED FOR THOSE SUPPLIED BY

MFS/YORK/STORMOR