Owner`s manual

015886 5-02

Important Pre-assembly Info

SIDEWALL SHEET IDENTIFICATION:

The bin wall sheets are color coded on the end of the sheets for easy reference as follows:

Red - 17 Gage Black - 12 Gage

Blue/Yellow - 15 Gage Orange - 11 Gage

Yellow - 14 Gage Brown - 10 Gage

To determine the number of sheets per ring, divide the bin diameter by three:

(ie: 36’ diameter bin divided by 3 = 12 sheets per ring.) Note: there are 36

roof sheets.

BIN HARDWARE AND WHERE IT IS USED:

#12 x 3/4” self drilling screw -

Used to attach the flashing sealer to the flashing.

1/4” x 3/4” bolts and flange nuts -

Used to bolt the dump hoppers to the plenum sheets.

Used to bolt the dump chutes to the dump hoppers (w/ 2 nuts).

5/16” x 1” bin bolts with seal washer and nuts -

Used in bin sidewall sheets and roof sheets.

Used around the door.

Used on the stiffeners.

Used at the door and step across platforms.

Used at the perforated and 10 gage skirts.

Used at the grain bands.

Used at the plenum sheets.

5/16” x 1 - 1/4” bin bolts with seal washers and nuts -

Used to bolt the bottom sidewall sheet to the base angle.

Used to bolt the purlin mounting angle to the sidewall.

5/16” x 2 3/4” bolts and nuts -

Used to bolt the plenum sheets to the plenum rafters at the grain band posts.

5/16” x 1” carriage bolts

Used to bolt the stiffeners together

5/16” flange nuts -

Used under all roof ribs and at plenum sheets.

Used at the perforated roof flashing.

Used at the grain bands.

Used at the stiffeners.