Owner`s manual

015886 5-02

Specifications (continued)

CHECK DELIVERY

Your bin has been carefully checked before shipment. However, you should check

your shipment upon arrival using the provided Packing List to insure it is complete.

SIDEWALL SHEET IDENTIFICATION

As an aid in identifying corrugated sheets on the packing list a series of codes are

used in the description. Typically the description begins with “COR SHT XX-

YYZ ....” Where XX is the diameter of the bin; YY is the gage; and Z is one or

more alpha numeric code designations. The codes used are as follows:

5 = Half sheet for entrance collar

6 = Door sheet for double punched sheets

7 = Door sheets for single punched sheets

E = Sidewall sheet punched for Ezee Dry Stiffener

F = Sidewall sheet punched for flashing

K = Tension sheet / Purlin Attachment

N = Ezee Dry fan entrance sheet

P = Double punched sidewall sheet

T = Transition sheet

Examples:

COR SHT 18-17EF is an 18’ diameter sheet punched for Ezee Dry stiffeners

and flashing.

COR SHT 36-10K is a 36’ diameter sheet punched for Ezee Dry purlins.

TORQUE

Torque specifications for the fasteners that bolt your bin together are listed below.

Have your contractor demonstrate that he/she is giving you the correct torque.

When you load or unload grain, always do it from the center. This creates an

even load on the structure. Only use your intermediate sumps for clean-up. Off-

center loading and unloading creates excessive stresses and can cause a failure.

All bins should be filled at the center of the peak ring with an auger or spout

of adequate length to allow grain to drop straight down into the bin.

Do not cut openings in bins. This reduces the structural strength of the unit

and can cause partial or complete failure.

Bolt Size Torque (ft/lbs)

5/16" Grade 8.2 25

3/8" Grade 5 31