Installation Guide

www.ezstripspacer.com
 Open box and remove one strip,
cut to length or use full strip
 Peel back paper from double sided
tape to expose adhesive Fig.1
 Place EZ-Strip Spacer™ on the edge
of the duct (The Manufacturer of
Reecx Insulaon suggest placing
spacers every 24 to 36 inches)
Fig.2
 Repeat on all four sides Fig.3
 Wrap insulaon around the duct
overlapping the edges Fig.4
 R6 (small bubble) Use Zip-Ez Fas-
teners™ down the seam, (just one
per foot) securing the insulaon
Fig.5
 R8 (large bubble) Aach as per
your manufactures instrucons
 Tape the seams as per the manu-
facturers instrucons
 For larger ducts add an EZ-Strip
Spacer™ down the center Fig.6
 For round pipe space EZ-Strip Spac-
ers™ equally as shown Fig.7
EZ-Strip Spacer™
INSTALLATION INSTRUCTIONS
J.T. Products, Inc. P.O. Box 626 Warwick, NY 10990
845.988.2000 Phone [phone] Fax
www.jtproducts.com
[e-mail]
Fig.1
Fig.2
Fig.3
Fig.4
Fig.5
Fig.6
Fig.7