Installation Guide

601 North Congress Ave., Suite 606, Delray Beach, FL 33445

561-303-3615 www.ezshelf.com

Suggested Shelf Heights:

Single Hanging: 60-80” from floor to top of the shelf.

Double Hanging, 82-84” from floor for top shelf and 40-42” for bottom shelf.

Included Plastic Parts

2 Tube Receivers

(note right and left)

1 Center Support

End Bracket(s) (if

ordered)

Shelf with Rod Parts

Shelf Parts

For EZ Installation, read all instructions and watch installation videos BEFORE beginning installation.

Installation videos: www.ezshelf.com/install.

1. Decide placement on back wall where shelf will end or two shelves will be joined. This is where you will

place your End Bracket. Find your End Bracket template and punch out along all dotted lines.

2. Measure from the floor up (see suggested shelf heights above if needed), and tape the End Bracket

template to the back wall. Make sure the template is level, and mark four screw holes with pencil.

3. Snap the Tube Receiver into the appropriate side of the End Bracket. Hold End Bracket up to wall to

ensure that correct Tube Receiver is snapped in.

 Note: For proper Tube Receiver installation: Larger holes on the Tube Receiver MUST be on the top

AND the small, protruding plastic tab MUST face the back wall. (see photo on next page)

Large Holes

on Top

Instructions using End Brackets

EZS-SCRW72-1-1

EZS-SCRW48-1-1

EZS-SCRW27-1-1

PAGE 1
Instructions using End Brackets EZS-SCRW72-1-1 EZS-SCRW48-1-1 EZS-SCRW27-1-1 601 North Congress Ave., Suite 606, Delray Beach, FL 33445 561-303-3615 www.ezshelf.com Suggested Shelf Heights: Single Hanging: 60-80” from floor to top of the shelf. Double Hanging, 82-84” from floor for top shelf and 40-42” for bottom shelf.
PAGE 2
Anchor/Screw Hole TAB should be touching against back of wall Left Tube Bracket – has smaller tube diameter than Right \ 4. Use included nuts and bolts to secure Tube Receiver to the End Bracket.  Pop the bolt into the End Bracket hole on the outside of the End Bracket.  Flip the End Bracket over.  Wrap the nut around the bolt and turn it a few times with your finger.  Flip the End Bracket back over and use a screwdriver to screw in the bolt. The nut will begin to move lower and lower on the bolt.
PAGE 3
10. Insert Top 5 Tubes into both Tube Receivers. Do not insert hanging tube (Bottom of “L”) until step 13. Twist both ends of tubes until fully seated. 11. Place Center Support so the tubes rest in the slots (preferably thicker part of tubes) & mark holes on back wall. Note: DO NOT rest Center Support on tube extension sleeves. 12. Attach Center Support (see 5-9 above) to back wall using anchors and screws. Note: Not all products include Center Supports. Garage Shelves include two Center Supports.