Installation Guide

METHOD 2 for Installation – When Expanding Tubes LESS Than 4”
(40 -73” Tubes - expanding 40” to LESS than 44”, 28-48” Tubes–expanding 28” to LESS than 32”,
64–118” Tubes –expanding 64” to LESS than 68”, 17.5-27” Tubes-expanding to LESS than 21.5”)
May be Difficult to Insert Tubes if extending LESS than 4” after mounting receivers.
1. MEASURE & MARK SIDE WALL FROM FLOOR UP
Shelf Heights: measure longest shirt or another item from floor to top of Hanging Rod.
Single Hanging: 60” - 80” from floor to *Top of Hanging Rod (not top of shelf).
Double Hanging: 80” - 84” from floor to *Top Hanging Rod & 40” - 42” for bottom shelf.
2. INSERT ALL TUBES INTO LEFT & RIGHT TUBE RECEIVERS
If Plugs on Tubes have Very Tight Fit into Tube Receivers:
Coat Plugs with a little Liquid Soap, WD40, or Vegetable Oil using paper towel or rag.
3. TAKE COMPLETED SHELF UNIT AND TAP ONE SIDE ON FLOOR
-then turn Unit around & Tap Other Side on Floor–make sure All Tubes are Secure
MOUNT CENTER SUPPORT BRACKET
If Putting a Lot of Weight on Shelf and/or Rod
(or if not evenly distributing weight, or if drywall may be damaged or weak)
Attach 1 side of Center Support to Stud with Screws & other side use Anchors/Screws to drywall
4. TAPE CENTER/END BRACKET TEMPLATE TO BACK WALL - Must be LEVEL.
5. MARK 4 SCREW HOLES & POKE through “X” on Template
- use Nail/Screw and then remove template from Back Wall
6. REPEAT STEPS 5-8 ABOVE
7. ATTACH to WALL with SCREWS–Place Center Support over anchors on wall.
DO NOT Over-Tighten Screws - too much pressure may put screw through plastic
part. Use power screwdriver/drill on Low
8. PLACE COMPLETED UNIT ON CENTER SUPPORT & EXPAND
9. MAKE SURE UNIT IS LEVEL
10. MARK LOCATIONS on SIDE WALLS for TUBE RECEIVERS
11. INSTALL ANCHORS - as per above
12. MOUNT TUBE RECEIVERS and SECURE with SCREWS as per above