Installation Guide

Mounting Tube Receivers to Sidewall
1. Measure & Mark Sidewall from floor up
Suggested Shelf Heights: measure longest shirt or other item from bottom to inside top of hook
Single Hanging: 60” - 80” from floor to top of Hanging Bar (not top of shelf).
Double Hanging: 80” - 84” from floor to top Hanging Bar & 40” - 42” for bottom shelf.
2. Tape Tube Receiver Template to sidewall – Must be Level.
3. Mark Four Screw Holes with Pen or screwdriver – poking through “X” on template
Tube Receiver Installation:Large Holes MUST be on Top & Small, Protruding TAB MUST touch back wall
4. Remove Tube Receiver Template from side wall
5. MAKE SURE THAT HOLES ARE LEVEL. Hold Tube Receiver to the screw holes & check with a level.
1. CHECK FOR STUDS–Push nail/screw into drywall-If it doesn’t go all the way in you may have hit stud or pipe
2. Drywall Anchor Instructions- Drill/Poke a small hole into wall. Push TIP ONLY of Anchor into
drywall & Screw in plastic anchors (see drywall anchor pictures below).
Use screwdriver/electric drill (on LOW setting – do NOT over tighten).
Note: EZ Shelf will hold 200 lbs. WITHOUT securing to studs.
Drywall Anchor & Screw Installation Diagrams
• If you hit a stud poking nail through drywall, do NOT use plastic anchors - secure screws directly to stud.
• For Plaster Walls – Do NOT use included plaster anchors/screws. Use plastic or lead anchors &
appropriate ¼” screws – available at local hardware store.
• For Concrete walls – Do NOT use included plaster anchors/screws. Use ¼” concrete anchors. You will
need to drill first (hammer drill is best) – available at local hardware store.
3. Attach to Wall with Appropriate Screws, after lining up smaller holes over the anchor holes on the wall. Do NOT
over-tighten screws-too much torque can put screw through bracket. Use electric screw driver/drill-Low Setting.
4. Opposite Wall - Measure the same distance from the floor as the first Tube Receiver & tape the template to the
wall. MAKE SURE THAT ALL HOLES ARE LEVEL with holes from 1
st
Tube Receiver.
TAB
MUST
TOUCH
BACK
WALL
Large
Holes on
Top
Anchor/Screw
Hole
1. Press Tip of
SnapSkru anchor
into Drywall using
screwdriver or
screw gun. Screw
anchor clockwise
into drywall until
anchor stops flush
with wall.
2. Place
item over
anchor &
insert
screw.
3.Tighten
screw
until flush
with item.
Left Tube Bracket: SMALLER diameter
Right Tube Bracket: LARGER diameter