Installation Guide

4. CHECK FOR STUDS–Push nail/screw into drywall-If it doesn’t go all the way in you may be hitting a stud or
other object.
5. Drywall Anchor Instructions- Drill/poke a small hole into wall. Push TIP ONLY of Anchor into
drywall & Screw in plastic anchors (see drywall anchor pictures below).
Use screwdriver/electric drill (on LOW setting – do NOT over tighten).
Note: EZ Shelf will hold 200 lbs. WITHOUT securing to studs.
Do NOT use included anchors when:
• You HIT A STUD: Drill “pilot” hole into stud & attach screw directly to stud.
• PLASTER WALLS: Drill “pilot” hole - Use plastic or lead anchors & appropriate screws.
• CONCRETE WALLS: Drill “pilot” hole (may need hammer drill) - Use concrete anchors/screws.
Drywall Anchor & Screw Installation Diagrams (see ezshelf.com/videos for more information):
6. Insert Back Tube (closest to back wall) into installed Tube Receiver (use hammer or mallet if necessary).
7. Attach Back Tube to other Tube Receiver and Extend to opposite sidewall.
8. Place Level on Back Tube & then also on Tube Receiver – Must be level - Mark Holes on wall with pencil.
9. Attach Tube Receiver to Wall (Repeat Steps 4 and 5 above from page 1)
10. Insert 4 other Top Tubes into both Tube Receivers. Do NOT insert Hanging Rod tube (Bottom of “L”) until
after step 13.
11. Twist both ends of tubes until fully secured.
12. Place Center Support so the tubes rest in the slots (preferably thicker part of tubes). To make sure Center
Support contacts ALL Tubes - Push center support UP from Bottom. Then Mark Holes on Back Wall.
13. Attach Center Support using anchors and screws (see steps 4-5 on page 1).
14. Insert Tube for Hanging Rod into both Tube Receivers.
1. Press Tip of
SnapSkru anchor
into Drywall
using screwdriver
or screw gun.
Screw anchor
clockwise into
drywall until
anchor stops
flush with wall.
2. Place
item
over
anchor &
insert
screw.
3.Tighten
screw
until
flush
with
item.
Note: DO NOT
rest Center
Support on
tube extension
sleeves.