Installation Guide

6. Insert Back Tube (closest to back wall) into installed Tube Receiver (use hammer or mallet if necessary).
7. Attach Back Tube to other Tube Receiver and Extend to opposite sidewall.
8. Place Level on Back Tube & then also on Tube Receiver – Must be level - Mark Holes on wall with pencil.
9. Attach Tube Receiver to Wall (Repeat Steps 4 and 5 above from page 1)
10. Insert 4 other Top Tubes into both Tube Receivers. Do NOT insert Hanging Rod tube (Bottom of “L”) until after step 13.
11. Twist both ends of tubes until fully secured.
12. Place Center Support so the tubes rest in the slots (preferably thicker part of tubes). To make sure Center Support
contacts ALL Tubes - Push center support UP from Bottom. Then Mark Holes on Back Wall.
13. Attach Center Support using anchors and screws (see steps 4-5 on page 1).
14. Insert Tube for Hanging Rod into both Tube Receivers.
Note: DO NOT
rest Center
Support on
tube extension
sleeves.