Instructions / Assembly

3) Counter sink and screw the first two rows to the base
4) Counter sink and screw gable ends to wall logs & screw purlins to gable ends
5) Use ratchet straps at all junctions and tighten down wall logs when fully assembled.
Tap walls & tighten pulling joints tight. Leave in place as long as possible
6) Install storm straps to outside corners behind the horn. Place the single hole at the
top log and secure and tighten the bolt. In the two lower slotted holes, install bolt
AT THE BOTTOM OF THE SLOT and finger tighten only. Now remove ratchet
straps and the logs will not open, but allow shrinkage.