Installation Instructions
Install all EZ-HANG brackets to the back of the door frame using the
1/2” screws provided where you would normally use wood shims.
Slightly loosen the screws just enough to remove the bracket
from the door frame. You will be re-installing the brackets over the
screwheads after you set the door into the opening.
Set the door as per any other manufacturers instructions from the
exterior of the building. Temporarily fasten in place from the outside.
From inside the building, re-install the EZ-HANG brackets over
plumb line is in the same spot on all the brackets by the hinges.
Install drywall screws through all brackets into the wall, adjust door
clearances as needed.
Finish installation by completing exterior fastening and any long
screws through hinges provided or recommended by the door
manufacturer.
2
ATTACH IT
MARK IT
Using a 6’ or 4’ level, draw a vertical plumb line on the wall 1/2” in
from the rough opening. This line must be on the hinge side and in the
room the door swings into.
3
HANG IT
EXTERIOR DOOR & wINDOw
I n s t a l l a t i o n I n s t r u c t i o n s
Visit: www.ezhangdoor.com for more installation tips and to view our online installation videos
INSIDE OF
OUTSIDE OF
3
1
NOTE: Edge stops are
releasable for non-drywall
installations.
1
3
2
Screw placement
At or slightly behind double
arrow for no drywall installed
At or slightly behind single
arrow for drywall installed
2
3
2
INTERIOR DOOR
I n s t a l l a t i o n I n s t r u c t i o n s
1
MARK IT
Using a 6’ or 4’ level, draw a vertical plumb line on the drywall
1/2” in from the rough opening. This line must be on the hinge
side and in the room the door swings into.
Screw brackets to back of door frame using the 1/2” screws provided.
Install brackets below each hinge and even with the edge of the door
frame. Repeat on the knob side of the door, starting 12” down from the top,
recommended for the top, on doors 30” and wider. The door is now ready to
insert in the rough opening.
Starting at the top hinge, match up one of
the lines on the bracket with the level line
drawn in step one. Screw door to the wall
using the drywall screws provided.
Work your way down the hinge side of the
door, making sure to use the same line for
each of the 3 hinge brackets. Next, check
the clearance between the frame and the
door on the top and knob side. Take care to
make sure they are equal. Starting at the top
again, continue working your way down the
door. Keep the clearance between the frame
and door equal, as you screw the door to the
wall with the drywall screws.
HANG IT
2
ATTACH IT
3
1
2
3
NOTE: For a premium installation, brackets may be used on both sides of an interior door. Add brackets to both the inside
and outside of the door. Remove from the outside (non hinge side) and re-install as in exterior instructions
Visit: www.ezhangdoor.com for more installation tips and to view our online installation videos
NOTE: Edge stops are
releasable for non-
drywall installations.