Installation Guide

INSTRUCTIONS:
1. Unscrew and remove present tub spout.
2.The water supply pipe
should be changed if it is
damaged or too long.
3.Diverter tub spout installation:
For tub with 1/2" IPS supply pipe
A) Do not remove bushing from
spout.
B) Screw spout onto nipple. Hand
tighten, align the spout by rotating
not more than one additional turn.
(Use teflon tape)
For tub with 3/4" IPS supply pipe
A) Remove reducing bushing from
spout-discard.
B) Screw spout onto nipple. Hand
tighten, align the spout by rotating
not more than one additional turn.
(Use teflon tape)
4. Slide shower support wall bracket (A) onto upper
riser (B). Loosen set screw for easy movement.
5. Thread upper riser (B) to lower section (C).
Thread shower head to upper riser (B).
Use teflon tape.
6. Line up assembled riser with connector nut (D)
and spout. Secure riser to wall with bracket (A)
using screws provided.
7. Thread spout connector nut (D) onto riser pipe.
Use teflon tape.
8. Secure riser bracket (A) to upper riser (B) with
set screw provided.
Spout Type Add-On Shower Unit
11120