Instructions / Assembly

Single Control

Kitchen Faucet

With Pull Down Spray

Before You Begin

Check to make sure you have the following:

10683

10685

Tools and Supplies

You will need the following to install your new faucet:

Adjustable

Wrench

Silicone

Sealant

Phillips

Screwdriver

PAGE 1
0683 10685 Single Control Kitchen Faucet With Pull Down Spray Before You Begin Check to make sure you have the following: Tools and Supplies You will need the following to install your new faucet: Adjustable Wrench Phillips Screwdriver Silicone Sealant
PAGE 2
Faucet Installation Shut off main water supply before installation. 1 Unscrew screws on lock nut. Remove the lock nut from the faucet body. 2 Install faucet through center hole. 3 Slide rubber washer and metal washer onto shank. Secure shank with lock nut. Protective Cap 4 Tighten end of shank with wrench and slip coupling nut onto inlet port. 5 Remove the protective cap from the outlet port prior to pushing the hose adapter onto the same port, you will hear a "click" sound once they are joined.
PAGE 3
Troubleshooting Guide Minor problems often can be fixed without a plumber. Before doing any work on the faucet, shut off water supply and close stopper or drain to avoid losing small parts. Problem Cause Solution Leaks underneath handle. Locking nut has come loose. O-ring on cartridge is dirty or damaged. Tighten the locking nut. Clean or replace O-ring. Hose does not retract. Metal weight is not installed in the appropriate position. Reinstall metal weight.