User Manual

II. Function Introduction

**Note:

Skip Read Error cannot fix the error on the source disc; all it does

is skip the errors and keeps copying the rest of the readable data.

• Change Bad Master: This setting will make the system eject a

bad source disc and ask for another one if the source disc is

unreadable by the system.

• CD Overburn: The majority of discs have a small margin of extra

groove at the outer edge. This setting allows you to copy data

over the normal size limit.

• Show HDD Image Name: You can select to show HDD image

name or capacity on Copy, Test, Copy + Compare and Compare

function

Show HDD Image Name: Show capacity:

**Note:

When you change the source from drive to HDD, the LCD

will show the HDD information. To change your source reader

please refer to 6. Select Source.

• Keep Buffer: You can set Yes to load source disc to buffer in first

round of Copy, Test, Compare or Copy+Compare and do it again

without the source disc. Or set No to keep buffer from being used.

**Note:

The source will only be temporarily saved in buffer, there will be

nothing left when you exit the task (Copy, Test, Compare and

Copy+Compare) or reboot the system.

• Boot Password: This setting allows you to enable or disable

the user administrative password. Users have to login when the

system is booted on.

• Setup Password: You can set up password by pressing to

select

the number you like and press to set next number.