Instructions / Assembly

10275 REV 10-07-15
3-Year Limited Warranty. Please register at www.ezaccess.com/warranty-satisfaction.
© EZ-ACCESS
®
, a division of Homecare Products, Inc. All rights reserved.
All text and images contained in this document are proprietary and may not be shared, modified,
distributed, reproduced, or reused without the express written permission of EZ-ACCESS.
Instructions
TRAVERSE™ Walk Ramp
with Optional Wheel Kit
The EZ-ACCESS
®
Traverse Walk Ramp Wheel Kit allows the
Traverse Walk Ramp to roll in lieu of being carried. Once
installed, per these instructions, the Wheel Kit is rated for the
weight of the ramp.
TABLE OF RATED LOADS (lbs.)
RAMP LENGTH
4’, 6’, 8’, & 10’
12’ & 14’
RATED LOAD
1,200
850
Install the Wheel Kit prior to ramp use.
1. Turn ramp on its side.
2. Install the Wheel Kit on either side of the ramp.
3. Use a tape measure to locate the center of the ramp side rail
then mark the area using an appropriate marker.
For 12’ & 14’ ramp lengths, the wheel kit will need to be
installed on the ramp side rail, adjacent to the flat bar.
4. Using the Wheel Kit mounting hole as a guide, mark the side
rail and drill a 3/8” hole through the side rail.
Do not drill through tread I-Beams.
Do not drill through flat bar on ramp side rail of 12’ & 14’
ramps.
5. Install by sliding the lip of the Wheel Kit frame under the hook
of ramp’s side rail then aligning the hole in the frame to the
hole drilled in the previous step (FIG. 3).
Ensure the Wheel Kit frame makes contact with the
surfaces of the side rail firmly.
6. Secure the Wheel Kit to the ramp using the supplied 5/16”-18
x 1” long hex bolt, two 5/16” washers, and 5/16”-18 nut
installed as shown (FIG. 3).
WARNING
Ramp Rated load: 1,200 lbs. for 4, 6, 8, & 10-FT lengths.
Rated load: 850 lbs. for 12 & 14-FT lengths. Do not exceed
rated load.
Wheel Kit Rated Load: The rated for the Wheel Kit is the
same as the ramp once assembled (see above).
Please refer to ramp's instruction sheet for proper ramp use,
safety guidelines, etc.
Do not roll ramp on uneven or sloped surface.
Use with care as the Traverse Walk Ramp Wheel Kit may
cause ramp to be unsteady while rolling or while stored on
edge (always secure ramp while storing).
Never leave ramp unattended when the Traverse Walk Ramp
Wheel Kit is in use.
FIG. 2
FIG. 3