Instructions / Assembly

Page | 7
FIG. 6
7.
ANCHOR
7.1 To ensure that the ramp does not move from its intended location, place the ramp and anchor both the
foot and the flap or, if the flap is not being used, anchor the foot only in the locations shown (FIG. 7).
Ensure that the ramp is securely anchored before each use.
7.1.1 ANCHOR TO WOOD OR ALUMINUM: Position the ramp and use the holes in the foot and flap
(foot only if the flap is not used) as a template to drill corresponding 1/8’’ holes into the landing
(ensure drilled holes are deep enough to fully seat each screw). Fully insert the provided 1/4" X
1’’ Long Self Drilling, Self Tapping Pan Head Phillips Screws through the pre-drilled holes and
into the corresponding drilled holes in the landing (FIG. 7).
7.1.2 ANCHOR TO CONCRETE: Position the ramp and use the holes in the foot and flap (foot only if
the flap is not used) as a template to identify anchor locations. Install non-provided anchoring
hardware flush with ramp’s surface (FIG. 7) and ensure that it does not create a hazard. It is the
installer’s responsibility to provide the appropriate 1/2" anchors for the type and thickness of
the concrete slab and install them per the manufacturer's instructions.
Concrete anchoring hardware is not provided.
When using non-provided anchoring hardware, follow hardware manufacturer’s
installation instructions. Ensure the hardware is of sufficient type and size to
prevent ramp slippage or undo movement.
FIG. 7