Instructions / Assembly

Page | 4
3.
COMPONENTS
3.1 Components will vary depending on ramp size purchased; please refer to TABLE 1 and FIG. 1.
PART NO.
COMPONENTS / EXTENSIONS INCLUDED
TMER 1 1” Extension (Foot), Flap
TMER 1.5 1” Extension (Foot), 1.5” Extension, Flap
TMER 2 1” Extension (Foot), 2” Extension, Flap
TMER 3 1” Extension (Foot), 2” Extension, 3” Extension, Flap
TMER 4 1” Extension (Foot), 2” Extension, 3” Extension, 4” Extension, Flap
TMER 5 1” Extension (Foot), 2” Extension, 3” Extension, 4” Extension, 5” Extension, Flap
TMER 6 1” Extension (Foot), 2” Extension, 3” Extension, 4” Extension, 5” Extension, 6” Extension, Flap
TABLE 1
FIG. 1
4.
CARE AND MAINTENANCE
4.1 Before each use, check the ramp for worn or damaged parts. If you find any of these conditions, do not
use the ramp.
Do not tamper with, attempt to repair, or modify any portion of the ramp.
4.2 Ensure that the ramp is always flush against the raised landing.
4.3 Before each use, tighten any loose fasteners.
4.4 Keep the ramp surface clear of ice, snow, dirt, leaves, and other debris. For ice and or snow, remove all
accumulations and sweep surface clean. For dirt, leaves, and other debris, sweep surface or wash with
a soft bristle brush and non-alkaline detergent, rinse well.
The ramp surface may be slippery in wet conditions. Use caution if surface is wet as traction
may be reduced.
4.5 Store the ramp in a cool, dry place when not in use.