Installation Guide

– 6 –
FIG. 6 FIG. 7
1.12 If two platforms are used to create a turn-back, connect platforms using a Dual Platform Connector
Kit.
1.12.1 On the first platform, install a dual platform connector on each of the two support tubes which
will be adjacent to the second platform. Make sure that the pocket of the connector is
oriented to the outside of the first platform, in the direction of the second platform and the
setscrews are facing in a direction where they will be accessible (FIG. 8).
1.12.2 Install legs and set the first platform at required height (as described in previous steps)
except make sure the dual platform connector is installed on the support tubes in the correct
orientation before bolting the feet.
1.12.3 Bring both connectors up until they touch the bottoms of the corner pockets in the first
platform and tighten the setscrews on the first platform side of the connectors securely
(FIG. 9).
1.12.4 On the second platform install the two legs which will be opposite the first platform and set
them to the same height as the first platform then set the two open corner pockets of the
second platform on top of the platform connectors and align the holes (FIG. 9).
1.12.5 Install two 1-1/2” square x 36” long tubes through platform corner pockets and connectors
until it aligns with bottom of connector and tighten all remaining setscrews securely (FIG. 10).