Installation Guide

– 3 –
MAINTENANCE:
Proper maintenance and upkeep to the system is vital. DO NOT USE if ramp guards, handrails, or supports are
damaged or unstable.
Do not use if surface is covered with ice and/or snow. Accumulation must be shoveled and the tread surface
swept clean before use.
At all times, keep system clear of dirt, leaves, and other debris that may accumulate on the surface.
Confirm that the system is correctly leveled and positioned securely. Periodically check for ground shifts.
Ensure all fasteners and locking mechanisms are in place and tightened. Regularly check and tighten as needed.
Ramp may be cleaned with mild detergent and warm water (consult manufacturer before using abrasives or
chemical cleaners). Rinse well and use extra caution when ramp surface is wet.
For additional care, use, or safety information, please call 1-800-258-8503.
TOOLS NEEDED:
 .......................................................................................................... Tape measure
 ......................................................................................................................... Level
 ............................................................................................. 9/16” socket or wrench
 ............................................................................................... 1/2” socket or wrench
 ............................................................................................... 3/16” hex key wrench
 ............................................................................................... 5/32” hex key wrench
 .................. 5/16” masonry drill bit (if installing ramp to concrete porch, steps, etc.)
 .................................................................................................................... Hammer
 .................................................................................................... #3 square drive bit
 ............................................................................................................................ File
 ................................................................................................................. Power drill
 ........................................................... Metal cutting chop saw or reciprocating saw
 ................................................. Digging tools (if an obstacle needs to be removed)
 .................................................... Two able-bodied persons needed for installation
 .......... Pop rivet gun (needed for child rail and corner cover plate installation only)
TABLE OF CONTENTS
Before You Begin, Symbol and Symbol Meanings, System Use 2
Tools Needed 2
Maintenance 3
Assemble/Set Platforms 3
Assemble/Set Ramps 9
Installing Transition Plate(S) 10
Installing Support Tubes (Legs) To Ramp Section(S) 11
Installing Platform Guards 14
Installing Ramp Guards 19
Installing Handrails 20
Installing Handrail Attachments 20
Final Steps 25
Notes 26