Instructions / Assembly

Page | 2
SYMBOLS
The WARNING symbol indicates a potentially hazardous condition/situation. The warnings throughout this
document, and on your equipment, if any, are for the protection of people and property. Failure to abide by
warnings will result in a waiver of all liabilities, loss of your warranty, and could result in equipment damage and
or failure, property damage, risk of serious bodily injury, and or death to operators, riders, and those nearby. The
symbol may appear in various colors and in conjunction with other symbols.
The NOTE symbol indicates important information. Failure to obey all notes could result in improper operation,
less-than-optimum equipment performance, and at the sole discretion of the equipment manufacturer, may void
your warranty. The symbol may appear in various colors and in conjunction with other symbols.
WARNINGS
Maximum weight capacity is 800 lbs.; never exceed weight capacity.
Prior to assembly and use, read and follow all instructions, warnings, and labels. Following all instructions and
obeying all warnings before and during use is necessary for safe operation. For additional information or to obtain
replacement copies of instructions or labels, call 1-800-451-1903.
For wheelchairs and scooters only; not for commercial use.
Before use, refer to your mobility equipment's owner guide for acceptable ramp usage, including proper
slope/incline, chair direction, etc.; never exceed its recommendations.
Only use the ramp with a qualified helper and always use a lap belt.
Before each use, check the ramp for worn, loose, or damaged parts. If you find any of these conditions, do not use
the ramp. Contact your dealer for service or repairs; failure to do so may cause injury.
Do not use the ramp if it is damaged or unstable.
Do not tamper with, attempt to repair, or modify any portion of the ramp.
Use caution when folding and unfolding the ramp to avoid all potential pinch points.
Ensure that the landings the ramp will be placed on are substantial and of sound construction.
Use only if the secure, unobstructed, level landings can support, at minimum, the same weight capacity as the
ramp (800 lbs.).
Ensure that the surface area of both top lip transition plates fully overlaps a secure, unobstructed, level landing
enough to safely install provided clevis pins or other non-provided anchoring hardware, and rests firmly against
the upper landing. If a secure, unobstructed, level landing cannot be attained, do not use the ramp.
Ensure that the ramp is securely anchored before each use.
Use only if sufficient maneuvering room is available at both ends of the ramp to assure safe travel when
entering and exiting the ramp.
The ramp surface may be slippery in wet conditions; use caution if the surface is wet as traction may be reduced.
Do not use the ramp if its surface is covered with ice, snow, dirt, leaves, or other debris. Remove all accumulations
and sweep the surface clean before use.
Improper use of the ramp could result in serious injury.
Always exercise caution when handling, installing, and or using the ramp.