Instructions / Assembly

PATHWAY
®
Aluminum Wheelchair Ramp Kit
Page 34 of 39
1
7.2. INSTALL RAMP HANDRAIL END LOOPS
7.2.1. Upper and lower end loops (FIG. 7.4) are installed in the same manner. If the end loop
being installed doesn’t fit correctly (i.e., the attachment plate is angled the wrong
direction, the lower leg seems too long or short, etc.), it is most likely being installed on
the wrong end of the ramp or ramp run.
7.2.1.1. Install the O-ring over the swaged portion of the end loop until it rests against the
loop shoulder (FIG. 7.5).
7.2.1.2. Install one 1/4” x 1” long hex washer head self-drilling screw through the hole in the
end loop attachment plate into the ramp handrail post.
7.2.1.3. Tighten securely (FIG. 7.6).
FIG. 7.4
FIG. 7.5
FIG. 7.6