Instructions / Assembly

PATHWAY
®
Aluminum Wheelchair Ramp Kit
Page 29 of 39
1
6.1.11. Reassemble elbow by replacing center insert and securing with screw and nut (FIG. 6.5).
6.1.12. Install a 5/16″-18 x 1″ hex bolt through a 5/16” flat washer and the upper hole in the angle post
into the 5/16”-18 round threaded insert (FIG. 6.6), then tighten all fasteners securely.
6.1.13. Test to ensure elbow is properly secured and attached. If needed, tighten internal set screws to
secure more rigidly.
6.1.14. Once the upper rail is in place, install the 1-1/2” x 2” curb.
6.1.15. Locate a platform closure bracket and clamp the short leg of the bracket to the ramp handrail
post 4” above the platform deck with the short leg aligned with the post. Orient the bracket so
that the long leg is on the same side as and parallel to the platform post (FIG. 6.7).
FIG. 6.5
FIG. 6.6
FIG. 6.7