Instructions / Assembly

PATHWAY

Aluminum Wheelchair Ramp Kit

Page 26 of 39

5.3. INSTALL PLATFORM HANDRAILS

5.3.1. Depending on the configuration, refer to FIGs. 5.4 and FIG. 5.5 as needed.

For U-shaped configurations, assemble handrails on both platforms as shown in FIG. 5.5.

5.3.2. Pre-assemble the platform handrail for both sides of a straight configuration and the “first″

handrail of a turn configuration. Make sure the unattached legs of the angle posts are on the

same side with respect to handrail tubes and curb and pointing outward (FIG. 5.4).

5.3.3. For the “second″ handrail in a turn configuration, only assemble one angle post as described

above, paying attention to how it will connect to the “first″ handrail so the angle post will be

oriented correctly.

5.3.4. For straight platform configurations and the “first″ handrail on a turn platform, drop

platform handrails into the corner pockets (FIG. 5.5). The curb should rest on top of the

corner pocket.

5.3.5. For the “second″ handrail on a turn platform, insert the angle post into a corner pocket at

90-degrees from the “first″ handrail, then install 5/16”-18 x 1” long hex bolt through a 5/16”

flat washer, the angle post in the “first” handrail, and into a 5/16”-18 threaded inserts in the

“second” handrail and curb (FIG. 5.5). Tighten all fasteners securely.

5.3.6. Tighten two each set screws on the inside of the platform corner pocket. One set screw is

located above the platform deck and the other is underneath (FIG. 5.4).

5.3.7. Install an angle cap on top of each handrail post. Use construction adhesive to bond the cap

in place (FIG. 5.3).

5.3.8. Ensure all fasteners are tightened securely.

FIG. 5.4

FIG. 5.5