Instructions / Assembly

PATHWAY

Aluminum Wheelchair Ramp Kit

Page 24 of 39

5. HANDRAILS

5.1. RAMP HANDRAILS

5.1.1. Two-line handrails are provided in pairs. One handrail is required on each side of the ramp, but

handrails are interchangeable side to side.

5.1.2. In configurations with more than one ramp in a run, handrail connectors (PRRC – CONNECTOR

RAMP TO RAMP) are used to join handrails together. Refer to FIGs. 5.1 and 5.2 for the following:

5.1.2.1. The vertical posts of the handrails each have two holes which correspond with the

studs on the end or center saddle brackets (installed in steps).

5.1.2.2. Attach handrails to the studs using two each 5/16″ flat washers and two each

5/16″ nuts per post. Tighten 5/16″ nuts just enough to hold handrail in place.

5.1.2.3. If the studs do not align with the posts in the handrail, the handrail end bracket

is most likely installed into the wrong threaded insert in the ramp side rail (see

FIG. 4.2 for proper installation location). Slide the ramp handrail connector into

one end of the upper handrail tube.

If connector does not fit in the tube, use pliers to lightly compress the

connector while sliding into handrail tube.

5.1.2.4. Slide the next handrail section over the connector, ensuring the upper handrail

tubes are pushed firmly towards each other. Compress the connector. Use a

rubber mallet or similar tool to fully seat as needed

5.1.2.5. Rotate the handrail until the holes in the handrail post align with the studs in the

saddle brackets that are connected to the ramp. Attach with 5/16″ flat washers

and 5/16″ nuts but tighten only enough to hold the handrail in place.

5.1.2.6. Repeat for the remaining handrails in the run, then tighten all fasteners securely.

FIG. 5.1

FIG. 5.2