Instructions / Assembly

PATHWAY
®
Aluminum Wheelchair Ramp Kit
Page 38 of 39
1
9. MAINTENANCE & SAFETY
9.1. PERIODIC MAINTENANCE AND SAFETY
9.1.1. Caution should be always used. Proper maintenance and upkeep to the ramp surface is vital.
9.1.2. Only use the system with a qualified helper.
9.1.3. Always use a lap belt if using the system with mobility equipment.
9.1.4. Before use with mobility equipment, refer to your mobility equipment's owner guide for
acceptable ramp usage, including proper slope/incline, chair direction, etc.; never exceed its
recommendations.
9.1.5. Before each use, check the system for worn, loose, or damaged parts. If you find any of these
conditions, do not use the system and contact your dealer for service or repairs; failure to do
so may result in serious injury.
9.1.6. At all times, keep the system clear of dirt, leaves, and other debris that may accumulate on
the surface. Simply sweeping the ramp or using a garden hose will usually suffice, but, if
needed, a damp cloth or soft brush with soap and water can be used (avoid use of alkaline
detergents).
9.1.7. If tread surface is covered with ice and/or snow, remove ice and/or snow before use. Snow
accumulation must be shoveled, and the tread surface swept clean. Magnesium Chloride may
be used to melt snow or ice accumulation on the ramp; however, after the snow and/or ice
threat has cleared, be sure to clean the tread surface with soap and water (avoiding alkaloid
detergents) to remove Magnesium Chloride residue. See DEICING below for additional
information.
9.1.8. Keep the system clear of debris and clutter. Do not use if walking surface is unsafe.
9.1.9. Do not run, jump, or play on or around the system, including climbing on or between the
handrails.
9.1.10. Do not use any part of the system to support planters, lights, decorations, etc.
9.1.11. The system may be slippery in wet conditions; use caution as traction may be reduced.
10. DEICING
For the safety of all users, it is important to keep your system clear of snow, ice, and other debris.
Always follow the deicing agent manufacturer’s directions.
EZ-ACCESS® will not be held responsible for any injuries or damages that arise from the information
provided. ALWAYS check with the deicing product’s manufacturer or your local supplier to determine
which method is best for your situation.
After the snow and/or ice threat has cleared, be sure to clean the tread surface with mild soap and water
(avoid alkaline detergents) to remove deicing residue.
Sodium Chloride (salt) and Calcium Chloride are particularly damaging to newly poured concrete. In
addition, these chemicals should not be applied to brick and stone surfaces.
While care has been taken to ensure that the table below is accurate, the information shown is not
all-inclusive. Manufacturers of deicing products may make changes to their products as well as
recommended functions and usage requirements. The deicing method you choose should be
researched with your deicer supplier so you can determine which method is best for your situation.
The information below is taken from Fact Sheet 707, Cooperative Extension Service, University of
Maryland at College Park, University of Maryland Eastern Shore and was up to date at the time of
this manual’s publication.
PRODUCT
MIN. WORKING
TEMP (
o
F)
SPEED OF ACTION
DAMAGES CONCRETE
& METAL
HARMFUL TO PLANTS
MAGNESIUM CHLORIDE
-13
VERY FAST
NO
MODERATE
CALCIUM CHLORIDE
5
FAST
YES
YES
SODIUM CHLORIDE (SALT)
18
MODERATE
YES
YES
POTASSIUM CHLORIDE
25
SLOW
OK ON OLD CONCRETE
MODERATE
CALCIUM MAGNESIUM ACETATE (CMA)
25
SLOW
NO
NO