Instructions / Assembly

Page 19 of 77
3.3.4. Locate the appropriate PHDSLxxPH SUPPORT LEG PAIR (where “xx” denotes the leg
length) for the location. Place a foot under the support leg bracket with the foot
extending under the ramp, then insert a 1-1/2” support leg through the support leg
bracket into the foot. Loosen the 3/8”-16 headless socket setscrews and the foot’s thumb
screw if needed to fully engage the support leg in the foot (FIG. 3.7).
If installing on soft soil it may be necessary to set the foot on a concrete pad.
3.3.5. After the support leg is fully engaged in the foot, tighten the 3/8”-16 headless socket
setscrews to 15 ft.-lbs. (FIG. 3.7).
Do not attempt to walk on the ramps until all support leg set screws have been
tightened as specified.
3.3.6. Tighten the foot’s thumb screw and insert 1-1/2” square plug into the top of support leg.
FIG. 3.7