Manual

Page | 34
INSTALLATION:
For a Straight Platform, measure 3/4” in from the end of one guard wall post and make a mark. Now measure
2-1/2” down from the top of the guard wall post (excluding the plug) and mark. Find the location where the two
marks cross. Mark a location on the other guard wall post 2-1/2” down from the top of the guard wall post
(excluding the plug) and 48-5/8” away from where the two marks cross on the opposite post. Drill 3/8” diameter
holes through both posts at the marked locations (FIG. 9.3A).
FIG. 9.3A
For a 90°Turn Platform, measure 5-3/16” in from the end of one rear guard wall post and make a mark on the
rear guard top rail. Now measure 1” down from the top of the rear guard wall top rail and mark. Find the
location where the two marks cross. Mark a location on the other end of the rear guard wall top rail 1” down
from the top and 48-5/8” away from where the two marks cross on the opposite side. Drill 3/8” diameter holes
through the rear guard wall top rail at the marked locations (FIG. 9.3B).
FIG. 9.3B
DRAWING IN THIS SECTION TO REFLECT
LOWERINGMOUNTING LOCATION, AND
REWRITE INSTRUCTIONS
DRAWING IN THIS SECTION TO REFLECT
LOWERINGMOUNTING LOCATION, AND
REWRITE INSTRUCTIONS