User Manual

Page | 8
7.1.4 Place one O-ring over the swaged portion of the end loop, then push until it rests against the
loop shoulder (FIG. 9).
7.1.5 Repeat for all end loops.
FIG. 9
7.1.6 Using a 1/4" driver of choice, install one 1/4” self-drilling, self-tapping hex washer head screw
through the hole in the end loop attachment plate and into the handrail post (FIG. 10).
7.1.7 Repeat for all end loops, then tighten securely.
If the end loop being installed does not fit correctly, ensure you have the correct loop for
the location. Refer to FIGs. 7 and 8 for upper/lower end loop identification.
FIG. 10