User Manual
Page | 6
6.5 Ramp handrail posts each have two holes that correspond with the studs on the brackets. Place the side
with the holes onto the bracket studs (FIG. 5).
Handrails are interchangeable from side to side.
6.5.1 Attach using (2 ea.) 5/16” washers and 5/16”-18 nuts per handrail post. Tighten securely with
1/2” socket or wrench.
6.5.2 Repeat for the second handrail on the opposite side of the ramp.
One handrail is required on each side of the ramp.
6.5.3 If end bracket studs do not align with holes in handrail posts, there are a couple of areas to
confirm:
① Ensure that the end bracket is installed into the proper threaded insert (see FIG. 4
for proper installation location).
② Ensure the orientation of the handrail section is correct. If necessary, flip the handrail
section 180-degrees so that ‘END #1’ is flipped to the ‘END #2’ position (FIG. 5).
FIG. 5