Instructions / Assembly

Page 22 of 74
3.3.10. Ensure that all bolts are tight and the ramp sections are aligned parallel to one
another.
FIG. 3.8
FIG. 3.9
INSTALL UNIVERSAL ANGLE BRACE - RAMPS
If the ramp walking surface is over 36″ high, a PUAB (UNIVERSAL ANGLE BRACE) must be installed
under the ramp (FIG. 3.9).
3.3.11. The opposite end of the angle brace is attached to the bottom of the ramp (near the
center of the tread at the end of the ramp) using a 1/4″ x 1” long self-drilling screw.
3.3.12. Ensure that all angle braces are secured before using the ramp.
Walking surfaces over 72″ or more above the ground require UNIVERSAL CROSS
BRACES in addition to the angle braces (see ‘INSTALL UNIVERSAL CROSS BRACE’
section). The process for installing cross braces to ramp legs and platform
support tubes is the same.