Instructions / Assembly

Page 58 of 74
6.2. INSTALL RAMP HANDRAIL END LOOPS
6.2.1. The PATHWAY 3G Modular Ramp System may include both upper and lower end
loops (FIG. 6.4). Upper and lower end loops are installed in the same manner. If the
end loop being installed doesn’t fit correctly (i.e. the attachment plate is angled the
wrong direction, the lower leg seems too long or short), you are most likely trying to
install it on the wrong end of the ramp or ramp run.
6.2.1.1. Install the o-ring over the swaged portion of the end loop until it rests
against the loop shoulder (FIG. 6.5).
FIG. 6.4
FIG. 6.5