Instructions / Assembly

1
PATHWAY
®
3G Modular Access System Assembly Manual Page 70 of 77
7.8. GATE
7.8.1. The Modular Gate 36” (“gate”) can be installed to swing in either direction. Determine which
side the hinge should be on and the direction the gate should swing before starting the
installation (FIG. 7.13).
7.8.2. Using a rubber mallet, tap the provided round tube plugs into the tubing ends (FIG. 7.14).
FIG. 7.13
FIG. 7.14
7.8.3. Position the gate hinge against the vertical handrail post. Position the hinge vertically so the
top of the gate is even with the top of the handrail and so that the edge of the hinge is flush
with the edge of the vertical handrail post.
7.8.4. Using the holes in the hinge as a template, mark locations with a pencil, then drill three 1/8”
holes through both sides of the vertical handrail tube (FIG. 7.15). Install fasteners through
hinge and vertical handrail post and secure as shown (FIG. 7.16).
FIG. 7.15
FIG. 7.16
DRILL 1/8” HOLES
1-1/2” DIAMETER
TUBE PLUG