Instructions / Assembly

PATHWAY

3G Modular Access System Assembly Manual Page 18 of 77

2.6.5.

INSTALL RAMPS ON LOW PROFILE PLATFORMS

This section addresses the attachment of a ramp (or ramp run) to a platform. If the

ramp needs to be angled with respect to the platform section, skip to ‘ANGLE RAMPS

WITH RESPECT TO PLATFORMS, PORCHES, OR DECKS’ in SECTION 3.

2.6.5.1.

Locate the PRHPLP (RAMP HANGER PAIR LOW PROFILE). Install two hangers onto

the side of the platform where the ramp will be attached.

2.6.5.2.

Hold the hanger perpendicular to the platform side rail, then bring the hanger

upward until it is against the side rail lip. Rotate the hanger and continue pushing

upward in such a manner that the “hook” at the top of the hanger goes behind and

catches on the lip in the top of the platform side rail and the hanger sits on the

ledge at the bottom (FIG. 2.13).

FIG. 2.13