Full Product Manual

PATHWAY

3G Modular Access System Assembly Manual Page 71 of 77

7.8.5.

Remove gravity latch and finger catch from bag.

7.8.5.1.

IMPORTANT! Discard the screws included in the same bag as the gravity latch

and finger catch, as they will not be used. Instead, use the screws included in the

separate hardware bag for the following steps.

7.8.6.

Center the finger catch on the gate square tube opposite the hinge and mark center of holes

with a pencil. Drill three 1/8” holes through one side of the vertical handrail tube (FIG. 7.17).

7.8.7.

Use a 1/4” nut driver to secure catch with screws (FIG. 7.18).

FIG. 7.17

FIG. 7.18

7.8.8.

Clip the latch to the finger catch and center on the step or ramp vertical square tube.

Mark center of the holes with a pencil, then drill four 1/8” holes through one side of the

vertical handrail tube (FIG. 7.19).

7.8.9.

Use a 1/4” nut driver to secure latch using screws (FIG. 7.20).

FIG. 7.19

FIG. 7.20

DRILL 1/8” HOLES

FINGER

CATCH